Skip to content Skip to left sidebar Skip to footer

Heating Measures and GJGNY Loans and Heating Repair

Program: EmPower+
To: EmPower+ Participating Contractors and Hubs
Summary: Heating Measures and GJGNY Loans and Heating Repair
Contact with Questions: Contractor Support at 1-800-284-9069 or email at support.residential@nyserda.ny.gov 

Financing Heating Systems

With the ending of EmPower+ incentives for fossil fuel heating equipment, EmPower+ will be adding two new measures in NYHEP to allow for the financing of furnaces/boilers through Green Jobs Green New York (GJGNY):​

  • Furnace Finance Only (FRNC_FO)​
  • Boiler Finance Only (BOIL_FO)​

These measures are to be used only when a contractor submits the measure for a loan through GJGNY. The measures will not receive EmPower+ incentives.

Heating and Hot Water Heater Repairs

Heating system and domestic hot water heating repairs will continue to be an eligible health and safety measure through EmPower+. If the total of all Health and Safety measures are greater than 30% of the project total, the cost of health and safety will count towards project level cost effectiveness.

When entering a heating or hot water heater repair, contractors will be required to list the issue and itemized costs in the notes section. An example of an acceptable note is provided below:

  • Furnace turns on and off. Home will not maintain temperature. New limit switch $150, New inducer motor $300

Per existing program requirements, the maximum incentive for heating system and domestic hot water heating repairs is $500 for low income and $250 for moderate income. 

The program is currently working with OTDA on a plan for working with low-income customers with no-heat situations during heating season. 

The above topics were covered on the August 1, 2025, Home Modernization monthly webinar which can be referenced here.

If you have any questions, please contact Contractor Support at 800- 284–9069 or email at support.residential@nyserda.ny.gov.